Reading wiring diagrams — the electrician’s language

📖 Leçon ──▶ 🎯 Quiz — choisis la traduction ──▶ ✅ Leçon terminée

A schematic shows connections as symbols: zigzag = resistor, triangle with arrows = LED, circle with M = motor. Golden rule: common GND! All parts share the same "ground" — otherwise signals don’t understand each other. Never mix 5V and 3.3V: a 3.3V sensor burns on 5V (the ESP32 is a 3.3V board). A schematic reads left to right: supply → load → ground. Same principle as our lab: from the red rail to the blue one through all parts.

●Pull-up/pull-down defines the pin’s "silence" — without it the input picks up noise
●A €15 multimeter is the main tool: the beeper mode checks connections
●Our <a href="/elektro/labor" class="underline">Circuit Lab</a> follows the same laws: gaps, polarity, resistors

📐 An Arduino pin supplies max 20 mA — enough for an LED, not a motor. For real loads you add a relay or MOSFET: the pin controls, the relay switches.

🎯

Teste-toi !

Consolide le sujet avec l’entraîneur — comme après le cours

Quiz — choisis la traduction → 🖨 Fiche de travail

← Précédente Suivante →