📐
Lecție 6 · clasă 14+
Reading wiring diagrams — the electrician’s language
📖 Lecție
──▶
🎯 Quiz — alege traducerea
──▶
✅ Lecție parcursă
A schematic shows connections as symbols: zigzag = resistor, triangle with arrows = LED, circle with M = motor. Golden rule: common GND! All parts share the same "ground" — otherwise signals don’t understand each other. Never mix 5V and 3.3V: a 3.3V sensor burns on 5V (the ESP32 is a 3.3V board). A schematic reads left to right: supply → load → ground. Same principle as our lab: from the red rail to the blue one through all parts.
- ●Pull-up/pull-down defines the pin’s "silence" — without it the input picks up noise
- ●A €15 multimeter is the main tool: the beeper mode checks connections
- ●Our <a href="/elektro/labor" class="underline">Circuit Lab</a> follows the same laws: gaps, polarity, resistors
📐 An Arduino pin supplies max 20 mA — enough for an LED, not a motor. For real loads you add a relay or MOSFET: the pin controls, the relay switches.